Whistling noise from Dash vents. 2010 V6 vert

[MustangAl]

Just recently, I am experiencing whistling noises. After a fair amount of troubleshooting, I have isolated the noise to the dash vents. When the fan is off, there is no noise. When the fan is high, the noise is louder. The noise only happens when the fan is exiting the dash vents. If it is either on defrost or coming at your feet, there is no noise. Even if there’s a combination of defrost and dash the noise disappears. I suspect that there a vent door that is not closing properly. Any help in diagnosing the problem or help with further troubleshooting would be appreciated.

[Minaccia]

The whistling noise in your 2010 Ford Mustang V6 convertible coming from the dash vents is likely related to airflow restrictions or issues with the vent door operation. Since the noise only occurs when the fan is set to blow air through the dash vents and goes away with other vent combinations, this points to a potential issue with the blend door, mode door, or an obstruction in the vent pathway. Here’s how to further diagnose and troubleshoot the issue:
Potential Causes:

Blend Door or Mode Door Issue:
The blend door or mode door controls the airflow direction. If it’s not closing or opening properly, it may create a whistling noise due to a partial blockage of the airflow.

Obstruction in the Vents:
Something small, like a piece of paper or leaves, could be partially blocking the vent, causing the whistling noise when air is pushed through at high speeds.

Loose or Worn-Out Seals:
There might be a loose or worn-out seal in the vent system or the HVAC unit, creating a gap that causes whistling when air passes through.

Blower Motor or Fan Issue:
A fan blade or component could be slightly out of alignment, making a noise when air is forced through a certain direction.

Troubleshooting Steps:

Check for Obstructions:
Use a flashlight and small inspection mirror to look inside the dash vents for any visible debris or obstructions.
Remove the blower motor resistor or blower motor to gain access to the vent pathways and clear out any obstructions.

Inspect the Blend Door and Mode Door Actuators:
Listen for any clicking noises when you change the airflow modes (e.g., defrost, dash vents, floor vents). Clicking or popping sounds usually indicate a faulty blend or mode door actuator.
Remove the glove box and access the actuators behind the dash. Manually operate the doors to see if they are moving freely or if there’s resistance.

Check the Blower Motor and Housing:
Remove the blower motor housing and inspect the fan for any misalignment or debris caught in the housing.
Make sure the fan is not loose and rotates smoothly without obstruction.

Inspect Vent Seals:
Check the seals around the vent doors and other HVAC components. If the seals are damaged or misaligned, replace them.

Check for Vacuum Leaks:
If your Mustang uses vacuum lines to control vent doors, a leak or disconnected line could cause the doors not to function properly, leading to unusual noises.

Next Steps:

If none of these steps resolves the issue, consider having a mechanic perform an HVAC diagnostic to pinpoint the exact cause. Sometimes accessing or fixing the blend or mode door requires removing parts of the dash, which can be complex and time-consuming without the proper tools and experience.

[MUSTANGWOP]

I have a similar issue with my 2019 ecoboost Escape. However mine only happens on acceleration from a stop and when the ventilation system is set to a lower cabin temperature. This happens with and without the A/C on no matter what vent selection or combination is being used. This sounds does not happen all the time with these conditions, just sporadic. I do have 3 or 4 videos of the sound and I'll try to upload it.

Edit... I can't get the videos to upload from my phone. I can email them to anyone who wants to take a stab at the issue.