And here’s a pic of the rear hanger that’s actually being pushed up rather than hanging down.
Attachment 26870
Attachment 26871
Printable View
And here’s a pic of the rear hanger that’s actually being pushed up rather than hanging down.
Attachment 26870
Attachment 26871
On a new exhaust install, not at all uncommon for the pipes to move / relax (yes even with clamps super tight) and need a touch up after the first few drives.
Not about clamps securing things in place, metal memory causing the issue.
Thats why we go insane trying to adjust a previously installed system where installer went wild with the mig on each and every connection.
As for lil bend / tweak req'd on the hangers, yup that happens almost every time.
Had 6 or 7 different axle backs on the 05, only one that bolted up with no bending or hassles and didn't move after heat cycling, Borla Touring.
I wish I could shim the hanger holder down but it’s bolted in a way that’s not really possible.
Attachment 26872
What's on my mind.... Would a 7.3L Godzilla engine fit in a 2016 Hyundai Santa Fe?!? :rockon:
I think the wifey would appreciate the increase performance ;)
Best part, engine will bolt right in with no mods required.
Went to get Halloween candy today. One store was out and the other had minimal left. Should I have bought ahead? Well I probably would have eaten most of it by now anyways.
Can't remember when I had to cut my lawn on October 30th. Usually cold and/or snow on the ground.