PDA

View Full Version : Fox T5 Overheating?



oneballsprite
06-18-2015, 10:07 PM
Hey guys. I have an 88 fox with t5. I bought it about a year ago. Second gear has always been hard to get in to, and this spring i had broken a couple napa clutch cables. I bought an oem cable, and billet quadrant and firewall adjuster. Its been doing well the past month.

Tonight i was running around town. Drove for approx an hour and noticed my console/shifter was getting very hot. I could barely touch the metal on the emergency brake handle. Will check the fluid level tomorrow.

My car has also recently lost all its power past 3500 rpm in third and fourth gear. Second gear also fades out around 4000 almost as if theres a limiter. It just so happens all this started after i got my car "alligned".

I have 3 things in mind.

Fuel system- bad pump or clogged filter
Clutch/trans- bent fork, broken clutch spring, blown tranny.
Ignition- spark plugs n wires. Eletrical short?

Not sure where to start.

needboost
06-18-2015, 10:13 PM
Only time my old tranny got hot it had no oil, ended up seizing the input shaft to the main shaft on a Tremec 3550 after about a 60 mile drive.

tulowd
06-18-2015, 11:34 PM
plugged catalytic converters

ZR
06-19-2015, 08:14 AM
Converter issue sounds very possible.

oneballsprite
06-19-2015, 11:19 PM
Wouldnt that require disconnecting just before the cats and taking a test drive?

ZR
06-20-2015, 05:34 AM
Stock front pipe?

ZR
06-20-2015, 06:23 AM
Decent read here on checking.

http://www.aa1car.com/library/exhaust_backpressure.htm

oneballsprite
06-20-2015, 07:28 AM
Mac shorty headers and dual flowmasters were on it when i bought it. I noticed a small leak at the manifold the other day. Would make sence if the cat is plugged, that pressure has to go somewhere

ZR
06-20-2015, 07:32 AM
No way to be sure until you check.

Tailites
06-20-2015, 12:37 PM
also whistling sounds...had that on one car when the cat quit

oneballsprite
06-21-2015, 11:28 PM
Trannys full. Took it for a bit of a hard run down the highway. Pulled over when things started getting hot inside but didnt see the cats glowing. Got the temperature gun out and read 300 on the pipe before the cat and 550 degrees on the exit of the cat. I have gained some power back after changing the fuel filter but the car still seems to struggle around 4500rpm and wot.