95 Mustang BBK U/D pulleys

[95GT_VERT]

have pulleys on my car, finally put a belt on it and hooked up the Alternator, The battery Light is on and even when holding a higher RPM it doesnt go out?

Is it a gaurentee that the BBK U/D on the alternator pulley is the issue, or would a new Alternator be the option? my current Alt history is unknown, its was dirtier then shit and i cleaned it up. Never tried it before now, its been sitting for 2 years.?

i just dont wanna buy a new alt if its just a pulley issue? Seems kinda dumb that BBK will sell something that causes charging issues.

Car has NO/AC or big stero either. I can try the old pulley but i thought i'd ask here first.

[95GT_VERT]

Another thing, I painted the altenator bracket so could that effect its ability to ground to the engine?

[95GT_VERT]

LOL...should mention.... I have added a couple extra grounds.

1 from passenger side header to frame rails. one from Drivers side engine to frame rail. 1 from altenator bolt all the way to the battery ground post. and of course the factory grounds in there factory harness.

[ZR]

If it's still on with increased RPM, either alt is pooched or you have a hook up issue. Got anyone local that can test the alt if you remove?

[95GT_VERT]

If it's still on with increased RPM, either alt is pooched or you have a hook up issue. Got anyone local that can test the alt if you remove?

Fixed it :)

[ZR]

What was the problem?

[RedSN]

the short, non-explanatory response suggests something embarrassingly simple.


*been there, done that*

[95GT_VERT]

I just wiggled the wiring connector at the altenator and it seems fine, I put some dielectric grease on them so if there connections weren't perfect they will be now. I checked the battery and at idle is was seeing 15 volts

[RedSN]

I just wiggled the wiring connector

:thumbsup: