MEANMCHN
09-11-2014, 09:15 PM
So over the winter Darren at Rev'N High installed new brakes on my car, the Baer Track 4 setup, with Baer pads and Baer rotors, matchy-matchy.
Picked up the parts from Shannon at WMS Racing.
Here are the fronts:
http://www.wmsracing.com/wmsweb/4261276R-BAER-TRACK-4-13-Red-front-1994-2004-Mustang-Fox-SN95.html
Here are the rears:
http://www.wmsracing.com/wmsweb/baer-ss4-12-rear-1994-2004-ford-mustang-solid-axle_moreinfo.html
1779
So far this year they have 2 races and roughly 800-900 laps and some street driving in between. Pads are like new and rotors are in near perfect shape other than some slight discoloration from the heat. Absolutely 0 warping, no loss of braking or pedal feel even after a hard 30 minute session in 80+ F weather. They're squealing free and make a surprisingly low amount of brake dust considering the hell I put them through, routinely stopping hard from over 220km/h and many downhill braking zones. On the looks side I've banged the inside of the wheel off of the caliper numerous times when mounting or removing the wheels and even under extreme heat there is no chipping, peeling or discoloration of the powder coating. If you're looking for an upgrade in the brakes department I'd consider these a perfect upgrade.
Picked up the parts from Shannon at WMS Racing.
Here are the fronts:
http://www.wmsracing.com/wmsweb/4261276R-BAER-TRACK-4-13-Red-front-1994-2004-Mustang-Fox-SN95.html
Here are the rears:
http://www.wmsracing.com/wmsweb/baer-ss4-12-rear-1994-2004-ford-mustang-solid-axle_moreinfo.html
1779
So far this year they have 2 races and roughly 800-900 laps and some street driving in between. Pads are like new and rotors are in near perfect shape other than some slight discoloration from the heat. Absolutely 0 warping, no loss of braking or pedal feel even after a hard 30 minute session in 80+ F weather. They're squealing free and make a surprisingly low amount of brake dust considering the hell I put them through, routinely stopping hard from over 220km/h and many downhill braking zones. On the looks side I've banged the inside of the wheel off of the caliper numerous times when mounting or removing the wheels and even under extreme heat there is no chipping, peeling or discoloration of the powder coating. If you're looking for an upgrade in the brakes department I'd consider these a perfect upgrade.