PDA

View Full Version : LTB- 91 Mustang AC Compressor



USAWIT2
06-14-2021, 07:41 PM
Might be a long shot but I'm looking for a good used AC compressor for my 91.
Or maybe someone might know where to get a seal kit so I can rebuild the one I havehttps://uploads.tapatalk-cdn.com/20210614/12dbdbae8db0f6e2be1d52eb8ba13537.jpg

Sent from my KB2005 using Tapatalk

ZR
06-14-2021, 08:44 PM
So common for them to leak between case (warp) find it more cost effective to replace with reman.
If you want to try a seal kit, look on Rock Auto, pretty sure they carry.

USAWIT2
06-14-2021, 08:55 PM
When it is warped is that leak internal? My system doesn't have any leaks, just doesn't seem to build much pressure.
Unit spins pretty freely by hand
I'll check Rock Auto again, didn't see a seal kit when I looked


Sent from my KB2005 using Tapatalk

ZR
06-14-2021, 09:07 PM
You would see the leak on the outside between middle / main body and either front or rear section.
Has it recently been apart or something happen to it?

ZR
06-14-2021, 09:10 PM
Looks like they only carry front seal for the clutch now.
Plugged or missing orifice tube maybe?
Does high or low PSI look normal or both low? Charge have an affect on either?

USAWIT2
06-14-2021, 09:17 PM
I had the system apart to do the heater core, I had it recharged and in the process realized the low and high side pressures weren't where they were suppose to be.
I also found that the pressure switch was jumped with a small bare wire (connector was plugged in to switch)

Sent from my KB2005 using Tapatalk

ZR
06-14-2021, 09:27 PM
Did AC previously work?

USAWIT2
06-14-2021, 10:02 PM
It seem too, didn't really use it that much being a vert and all.
I assume they jumped the switch because it was bad or the compressor was or the compressor went bad because they jumped the switch

Sent from my KB2005 using Tapatalk

ZR
06-14-2021, 10:03 PM
Sometimes it's as simple as they had no idea all it needed was a shot of freon to bring psi up enough to engage.

Frankie
06-16-2021, 08:24 AM
I have a scrapper compressor sitting here if you decide to rebuild yourself and need some parts.

4GOTNPNY
08-31-2021, 11:25 AM
i have a compressor as well not sure if it works but its on my bench its in scarborough or whitby whatever is closer for you

Mustang4
08-31-2021, 07:29 PM
I might have an extra one as well. Will check.