Husky mini air pump (AC 120V) hose repair?

[92redragtop]

I have a Husky mini air pump/inflator (AC 120V) that is leaking where the air hose connects to the unit/pump (right side) - anyone repair these at home?

https://www.homedepot.ca/product/husky-120-volt-inflator/1000657842

This is an extra unit so didn't want to throw it out since the pump itself works fine.

If repairable, does anyone local want it to try and repair if you need a pump? It's a nice little unit and works faster than the small DC units.


21130

[5.4MarkVIII]

I think you can buy replacement hoses for those. Or worst case hose is most likely just a standard pipe thread into the compressor body.

[92redragtop]

I think you can buy replacement hoses for those. Or worst case hose is most likely just a standard pipe thread into the compressor body.

Yeah, looks like the fitting into the motor can be unbolted but I wasn't sure about removing the hose going into the fitting and reinserting a good piece (maybe cut an inch off and replace into fitting?).

Not sure about replacement hoses - did.t see them at HD but maybe Princess Auto has generic hoses like on this one.

I just bought a new one but figured someone else might be able to use this one.

[RedSN]

Great to use on a Bendpak lift if anybody has one. Plumb it right into the air locks.

[Stephen06GT]

PM sent.