? Stance ?

[Whitehot]

My 99 GT seems to have a little lean to it. From the back it looks good, even and all that,but when I measure the wheel well, form the ground I get a 3/4 " difference?? I m wondering what that could be? It goes to the shop to be looked at in week or so... I was thinkin a cracked spring?? or something?? ... Passenger ft is about 26 1/4 , passenger ft is about 26 1/2... Driver side is about 26 1/2 ft and 27 7/8 at the bk....thats measuring at the tire, centre to the wheel well.... Any thoughts??

[NITEMARE]

This is normal ... in my experience it's very tough to have a new edge sit perfectly even on all 4 corners from ground to fender lip. Even my cobra isnt perfect

[Whitehot]

? I just thought more than half inch is alot?? ... seemed like almost 3/4 inch depending on reading tape measure..:)

[ZR]

It's 100% normal on a Fox, somewhat common on New Edge.

[Laffs]

My driver side rear is about 1/2 lower than the passenger side rear. These chassis weren't exactly the most rigid from factory. Driven spiritedly without major reinforcements will tweak them easily.

[ZR]

Even some never been driven hard virgin cars are out to lunch.

[bbriann]

My 2004 had lean from new..

[hammerhead]

My 79 fox leaned about an inch on the right side - I've been doing some fab work and tried to correct it and it think it now leans to the left lol - I remove every piece of suspension and did t really see anything to cause the lean and think it is just fatigue